DWS 028
- Dental Resins
- Jewelry Resins
- FAQs
-
Profile Settings for 3D Printers
Anycubic 3D Printers Settings Phrozen 3D Printers Settings Elegoo 3D Printers Settings Flashforge 3D Printers Settings Wanhao 3D Printers Settings Epax 3D Printers Settings Longer 3D Printers Settings Creality 3D Printers Settings Nova3D Printers Settings Peoply 3D Printers Settings Zortrax 3D Printers Settings
- Digital Jewelry Production
- Digital Dental Production
- Blog
DWS 028
For DWS 3D Printers, we recommend to use PowerResins SLA castable resin. This resin is specially developped for SLA 3D Printers such as DWS or Formlabs.
We are publishing here the required parameters that you can use for the model DWS 028 however you can easily adapt these settings for other DWS models.
Settings for DWS 028 3D Printer
In order to use PowerResins SLA resin with DWS 028 3d printer, we recommend to do the following step:
Switch off the heating of the resin tank. The resin vat is heated in DWS machines in order to lower the viscosity of the resin. With PowerResins castable resin, you don't need to lower the viscosity and we recommend to switch off the heater.
Setup the printing parameters.
1. Disable the heating of the tank by unplugging the heater cable
2. Setup the parameters from the slicing software
We first setup the layers parameters by useing the DC550 parameters. You can edit the DC550 parameters and use the details below:
Then on the process tab, please make sure to have these parameters:
Finally, you can edit the parameters to setup speed as follows: